Filter
Top Products
36
www.pridemobility.com Celebrity XL
VIII. BASIC TROUBLESHOOTING
What if all the systems on my scooter seem to be “dead”?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Scooter.”
Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VII.
“Disassembly and Assembly.”
Be sure the power down timer feature hasn’t been activated. See V. “Operation.”
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and can
no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic beep code will sound in the event one of the conditions listed below develops.
NOTE: Your scooter will not run unless the beep code condition is resolved and the scooter has been
turned off, then turned back on.
BEEP CODE CONDITION SOLUTION
(1,1)
Controller is hot; the scooter seems to be
losing power.
Shut down your scooter for a
minimum of several minutes to
allow the controller to cool.
(1,4)
(3,3)
Battery charge is low. Charge batteries as soon as possible.
(1,2)
Throttle pot fault.
Contact your authorized Pride
Provider for assistance.
(1,3)
Speed pot fault.
Contact your authorized Pride
Provider for assistance.
(1,5)
Attempting to operate the scooter with
the charger attached.
Turn the scooter key to the off
position. Switch off the charger and
remove the cord from the charger port,
then restart your scooter.
(3,5)
Throttle control lever not at center
position at start up.
Return the throttle control lever to
center position, turn scooter off, and
then back on.
(3,4)
The manual freewheel lever may be in the
freewheel (forward) position.
Turn the scooter key to the off
position. Push the freewheel lever to
the drive (backward) position, then
restart your scooter.
(3,2)
A brake fault has occurred.
Contact your authorized Pride
Provider for assistance.