Filter
Top Products
21
Celebrity XL www.pridemobility.com
III. YOUR SCOOTER
WARNING! When your scooter is in freewheel mode, the braking system is disengaged.
Disengage the drive motors only on a level surface.
Ensure the key is removed from the key switch.
Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on
a scooter to do this.
After you have finished pushing your scooter, always return it to the drive mode to
lock the brakes.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in
the “on” position, the scooter will not run until the manual freewheel lever is pushed backward and the
key is turned to the “off” position, then back to the “on” position.
Safety Flag Bracket
An accessory bracket for installing an optional
safety flag is mounted near each anti-tip wheel. To
install the flag, the supplied “L” shaped hex key is
needed. See figure 8A.
Installation:
1. Remove the cap from the top of the bracket.
2. Loosen the setscrew with the supplied “L”
shaped hex key.
3. Insert the flag pole into the opening.
4. Tighten the setscrew to complete installation.
Main Circuit Breaker (Reset Button)
When the voltage in the batteries becomes low or
your scooter is heavily strained because of exces-
sive loads, the main circuit breaker may trip to
protect the motor and electronics from damage.
When the breaker trips, the entire electrical system
shuts down. See figure 9.
The reset button pops out when the breaker
trips.
Allow a minute or so for the electronics to
“rest.”
Push in the reset button to reset the breaker.
If the breaker trips frequently, you may need to
charge the batteries more often or have your
authorized Pride Provider perform a load test
on the batteries.
Figure 8A. Safety Flag Bracket
HEX KEY
SETSCREW
CAP
MAIN CIRCUIT BREAKER (RESET BUTTON)
Figure 9. Main Circuit Breaker (Reset Button)