Filter
Top Products
22
www.pridemobility.com Celebrity/RevH/Apr03
Your Celebrity is equipped with two long-lasting, 12-
volt, deep-cycle batteries that are sealed and mainte-
nance free. They are recharged by an onboard 3-amp
charging system designed for ease of use and conve-
nience. See figure 8.
n Charge your Celebritys batteries prior to using it
for the first time.
n Keep your batteries fully charged to keep your Ce-
lebrity running trouble free.
Follow these easy steps to charge your
batteries safely:
1. Position your scooter close to a standard wall outlet.
2. Remove the key from the key switch.
3. Extend the charger power cord and plug it into the
wall outlet. See figure 10.
VI. BATTERIES AND CHARGING
Figure 10. Charger Power Cord
Figure 11. Ammeter Indicates Battery Is
Fully Charged
WARNING! Never use an extension cord to plug in your battery charger. Plug the charger
directly into a properly wired standard wall outlet.
WARNING! Removal of the grounding prong can
create an electrical hazard. If necessary
properly install an approved 3-prong adaptor to
an electrical outlet having 2-pronged plug
access. Failure to heed could result in personal
injury and or property damage.
NOTE: There is a charger inhibit on your scooter. The scooter
will not run and the battery condition meter will not operate while
the batteries are charging.
4. It is recommended that you charge your batteries for 8 to 14
hours. You can check this periodically by the battery condition
meter on the control console assembly. However, you must first
unplug the battery charger and then insert the key. The battery
condition meter on the control console assembly indicates the
approximate strength of your batteries. When fully charged, the
meter reads 24 volts. You can also check the charge by the
ammeter which is located on the utility tray under the rear
shroud. The battery charger must be plugged into a wall outlet
to obtain a reading. When the amperage reading is at or near
zero (0) amps, the battery charging is complete. See figure 11.
5. When the batteries are fully charged, unplug the charger power
cord from the wall outlet, then coil the cord and store it under
the utility try lid.