Filter
Top Products
24 www.quantumrehab.com Quantum 6000Z Series
IV. ASSEMBLY
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair. Contour
seats are attached to the power base with the Universal
Mounting System (UMS). The UMS consists of universal
parts that may be attached to the seat, regardless of seat
width or seat depth. The two main components are alumi-
num extrusions mounted to the seat base. These extrusions
attach to a pair of trapeze bars that are mounted to the
power base. See figure 11.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or a Synergy TRU-Balance
Power Positioning System, refer to the information
provided in separate manuals.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 11.
2. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
3. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
4. Install the controller and route the cable to the back of
the power base. See figures 12 and 13.
5. Loosen the rear shroud fasteners and remove the rear
shroud. See figure 6.
6. Plug the controller connector into the power base. See
figure 7.
7. Replace the rear shroud and tighten the rear shroud
fasteners. See figure 6.
8. Secure the controller cable to the armrest receiver with
wire ties (contour seats only). See figure 13.
WARNING! Prevent controller harness
damage! Use correct tie-down points for
controller harness.
Figure 11. Universal Mounting System and Contour
Seat
SEAT
LATCH
SAFETY
REAR
EXTRUSION
FRONT
EXTRUSION
TRAPEZE
BARS
Figure 12. Controller Routed on a Synergy Seat