Filter
Top Products
8 www.pridemobility.com Commander 400
III. INSTALLATION
LIFT SYSTEM INSTALLATION
NOTE: The lift system is an exterior-rated lift system. Refer to the online compatibility database located
at www.pridemobility.com for information concerning lift system/vehicle compatibility, or contact your
authorized Pride Provider.
WARNING! The lift system should be installed by an authorized service technician only.
WARNING! At least two people should lift the lift system into the rear of the vehicle. Use
proper lifting techniques and avoid lifting beyond your physical capability.
WARNING! Avoid pinch points! Do not hold the lift frame by the pivot points when
installing the lift system.
NOTE: Footprint the mounting area along with the lift and mobility device to make sure all clearances
pass above and below vehicle without any interference before starting installation.
NOTE: Use only the supplied hardware to install the lift system.
NOTE: To preserve vehicle-system data, the vehicle’s power system may need to be connected to an
alternate power source prior to battery removal. Refer to the vehicle’s owner’s manual for information
on proper battery-disconnection instructions.
Follow these steps for installation:
1. Install the lift system securement system to the vehicle.
NOTE: Securement systems vary depending on vehicle manufacturer. Pride recommends use of only
the securement system provided with the lift and that you follow all instructions provided by the manu-
facturer for installation.
2. Connect the lift system to a power source. See “Wiring Harness Installation.”
3. Ensure that all mounting hardware is fully tightened and all required clearances have been achieved.
NOTE: The lift system may include an optional set of L-Base extensions. For information on L-base
extension installation, refer to the supplemental instructions or contact your authorized Pride Provider.
NOTE: The lift system is equipped with a power base, which is an automated device designed to rotate
the boom arm left and right.