Filter
Top Products
10 www.pridemobility.com Commander 400
To raise or lower the boom arm:
1. Support the boom arm.
2. Remove the detent pin located between the
boom arm and upper post. Guide the boom
arm upward or downward to the desired posi-
tion. See figure 4.
3. Reinsert the detent pin into the top of the upper
post to secure the boom arm in place. See
figure 4.
ELECTRICAL WIRING INSTALLATION
1. Route the hard wire kit (starting at the lift)
through the interior of the vehicle until you
reach the automobile battery. See figure 5.
Conceal the wire behind or under the interior
panels. Be certain that the wire is protected
with a rubber grommet when passing it
through the metal panels and into the engine
compartment. Inside the engine compartment,
secure the wire to the firewall and the inner
fender with the supplied plastic wire ties. Use
care not to cause abrasions to the power wire.
It is important to secure the power wire at
various points along its run.
III. INSTALLATION
PINCH
POINT
2. Insert the red positive (+) lead on the power
wire into the spliced end of the red positive (+)
battery lead, then crimp the splice to secure the
wire.
3. Connect the red positive (+) battery lead to the
positive (+) battery terminal and the black
negative (-) ground wire to the negative (-)
battery terminal.
WARNING! The red positive (+)
wire must be connected directly to
the positive (+) battery terminal.
WARNING! The black negative (-)
wire must be connected directly to
the negative (-) battery terminal.
4. Connect the harness extending from the motor
housing to the harness coming from the
battery.
Figure 4. Securing the Boom Arm
DETENT
PIN