Filter
Top Products
42 www.pridemobility.com Jazzy 1400/Rev C/Sept02
X. CARE AND MAINTENANCE
4. Separate the two halves of the wheel by removing the 6 retaining bolts with a 3/16-in. hex key.
5. Remove the old tube and/or tyre and replace it with a new tube and/or tyre.
6. Install the tyre (with the tube inside) onto the wheel.
7. Slide the wheel back onto the shaft.
8. Install and tighten the drive wheel bolt into the center hub.
9. Inflate the tyre to 30–35 psi.
BATTERY REPLACEMENT
A diagram is printed on a decal located on the Jazzy 1400 frame near the battery tray.
To replace the batteries:
1. Turn the power off.
2. Unplug the controller wire harness.
3. Remove the seat.
4. Remove the body shroud.
5. Loosen the wing nuts on the positive (red) battery terminals first.
6. Remove the wires.
7. Loosen the wing nuts on the negative (black) battery terminals.
8. Remove the wires.
9. Replace the batteries.
10. Install the batteries into your Jazzy 1400 with the terminal sides of the batteries facing inward, toward
each other.
11. Connect the wire marked (+) to the closest positive (red) battery terminal.
12. Connect the wire marked (-) to the closest negative (black) battery terminal on the other battery.
13. Connect one circuit breaker harness to the empty positive (red) terminal of one battery, and connect the
other circuit breaker harness to the empty negative (black) terminal of the other battery.
MOTOR BRUSHES
NOTE
:
Failure to maintain the motor brushes could void your Jazzy 1400’s warranty.
The electric motors that power your Jazzy 1400 use carbon brushes. These brushes may become susceptible
to wear over a long period of time. The motor brushes are the two contacts located inside the motor assembly
that transfer power to the motor. They are designed to provide several thousand hours of operation. However,
if the brushes become dirty with carbon deposits or if the brushes wear out, the motor will run poorly or not
at all. We recommend that your authorised Pride provider inspect the brushes every six months, or sooner
if your Jazzy 1400 runs poorly. If inspection determines excessive wear on the brushes, they must be
replaced or motor damage will result.