Filter
Top Products
Jazzy 1400/Rev C/Sept02 www.pridemobility.com 31
VIII. OPERATION
To arm the lockout system:
1. Hold the magnetic key on or near the key symbol. The controller beeps and automatically powers
down. No LEDs should be on.
2. Press the on/off key to power up the chair. The key LED flashes, but you will not be able to drive the
power chair because the controller is still locked.
3. Hold the magnetic key on or near the key symbol again to unlock the system. When the key LED stops
flashing, you may drive your Jazzy.
If you turn on the controller while it is locked and don’t unlock it after one minute, the controller automatically
turns itself off.
ON/OFF KEY
This key switches the system power on and off.
HORN KEY
This key activates the horn.
SYSTEM STATUS INDICATOR
This LED indicates system status. It is normally on when the system is powered up and off when the system
is powered down. It also flashes trouble codes when the system detects a fault. See “Trouble Codes.”
DRIVE MODE SELECT KEY
This key enables you to select a drive program. This mode also consists of a seven segment LED that
displays the drive program. It also displays whether or not the inhibit is enabled and flashes if there is an
OONAPU or DX/Remote fault. See “Out Of Neutral At Power Up.”
DRIVE MODE INDICATOR
Your Jazzy controller was pre-programmed at the factory for five drive modes: 1 (slowest) to 5 (fastest).
The program mode is indicated by a number in the center of the keypad. Press the Drive Mode Select Key
to change the mode.
NOTE
:
We recommend that the first few times you operate your Jazzy 1400 you have your drive mode on
the slowest setting until you become familiar with your new power wheelchair.