Filter
Top Products
8
ᕩ
ᕫᕾ
ᕫᕵ
ᕫᕶ
ᕫᕷ
9. You are now ready to configure PelcoNet. Type service (lowercase).
Press Enter. This brings up the menu.
10. Press the i key to access the IP menu.
11. Press the i key again to set the IP address. Type the new IP address
PelcoNet will be using on the network. Press Enter.
12. Press the s key to set the subnet mask. Type the new subnet mask. Press
Enter.
13. Press the g key to set the gateway IP address. Type the new gateway IP
address. Press Enter.
14. Close HyperTerminal. If prompted to save the settings, click OK.