Filter
Top Products
14
ᕥ
ᕤ
STEP 3
FINAL CONNECTION SETTINGS
If you changed the transmitter and receiver IP addresses in STEP 2, then use the
new addresses to connect to the units. Also use the new addresses to make
changes to any settings. If no changes were made to the IP addresses in STEP 2,
use the default address for the transmitter (10.0.0.1) and the default address for
the receiver (10.0.0.2).
1. Install Internet Explorer 6.0 (if you have not already done so) from the
CD supplied with PelcoNet NET350 on to a computer connected to
the network.
2. Open Internet Explorer 6.0.
3. Type the receiver’s IP address in the address field, and then press Enter
to connect to the receiver.
4. Click the Setup icon.
5. Click Alarm Settings to bring up the Alarm Settings page.