Filter
Top Products
20
English
Pulse detection mark
4. Press the Off/On Start button.
The display will be lit up for approx.
2 seconds.
The cuff will begin to inflate automatically.
As measurements are being taken
during pressurization, operating sounds
and the rate of pressurization may
change. This is perfectly normal.
The pulse detection mark will be displayed
graphically during pressurization when the
pulse is detected.
•
•
•
5. When measurements have been
completed, blood pressure and pulse rate
are displayed.
Pressure will automatically be released
from the pressure cuff.
If your blood pressure is considered to be
in the hypertensive range, then the
readings on the display will flash for
approx. 6 seconds. (Please see page 21.)
Measurement results are also displayed as
graph. (Please see page 21.)
The mark will be flash.
(Please pages 26 and 27 for details
regarding how to record readings.)
The pulse is estimated over the period of a
minute based on the pulse rate recorded
when measurements were being taken.
•
•
•
•
•
6. Press the Off/On Start button to turn off
the unit.
If you forget to switch the device off, it will
do so automatically after approx. 5 minutes.
•