Filter
Top Products
10
2.Preparation
2.2 Setting the Date and Time
Your blood pressure monitor automatically stores up to 90 measure-
ment values in its memory and calculates an average value based
on the last three measurements. If the correct date and time has not
been set, the measurement values will not be stored in memory. To
make use of the memory and average value function:
• Set the monitor to the correct date and time before taking a mea-
surement for the first time.
• If the batteries have been removed for a long period of time, the
date and time setting will need to be reset.
1. When the batteries are installed for
the first time, the year digits (2004)
will flash on the display when you
turn on the monitor.
Notes:
• The range for the year setting is 2004 to 2030. If the year
reaches 2030, it will return to 2004.
• If you need to reset the date and time, press the SET button
until the setting you want to adjust appears on the display,
then press the MEM button to change the setting.
2. Press the MEM button to advance
the digits one at a time.
Note: If you hold down the MEM
button, the digits will
advance rapidly.
3. Press the SET button to confirm the
setting when the desired number
appears on the display.
The year setting is set and the
month digits will flash.
HEM600-E.book Page 10 Thursday, November 13, 2008 10:26 AM