Filter
Top Products
24
Adjust the “Refresh Rate” (minimum is 0.2 sec) and Min / Max to suit your viewing needs.
Note that the setting of curve colors and other parameters must be done in the “System Configuration”
window pane. Up to 64 trends can be displayed.
7.3.2.2 Displaying analog thermometers
Click the “Thermo” button; the following window will appear.
All thermometers share the same Min / Max reading setting. Refresh rate is fixed at 1.0 sec. The size of this
window will change depending on the number of channels to display. Up to 16 thermometers can be shown;
if you want to display more than 16 channels, only the first 16 detected channels will be shown (note that any
channel that has its “Chart” checkbox unchecked, in the main window, will not be shown).
If an alarm is active for a channel, the corresponding thermometer numbers will change color: blue for a low
temperature alarm, or red for a high temperature alarm.
7.3.2.3 Displaying digital values
To display digital temperatures, click on the “Digital” button. The following window will appear.
The size of this window will adapt to the number of channels to display. Up to 32 values can be shown.
Refresh rate is always 1.0 sec. This window is re-scalable.
If an alarm is active for a channel, the corresponding display will change color: blue for a low temperature
alarm, or red for a high temperature alarm.
7.3.2.4 Displaying analog values (dials)
To display analog temperatures (using dials), click on the “Analog” button. The active window becomes this: