Omega Engineering CYD201 and CYD208 Thermometer User Manual


 
OMEGA Model CYD201/CYD208 User’s Manual
Installation 2-1
CHAPTER 2
INSTALLATION
2.0 GENERAL
This chapter covers Inspection and Unpacking (Paragraph 2.1),
Repackaging for Shipment (Paragraph 2.2), Sensor Installation
Recommendations (Paragraph 2.3) Power and Ground Requirements
(Paragraph 2.4), Sensor Curve Definitions (Paragraph 2.5), and Rack
Mounting (Paragraph 2.6).
2.1 INSPECTION AND UNPACKING
Remove packing list and verify receipt of all equipment. For question
about the shipment, please call OMEGA Customer Service Department at
1-800-622-2378 or (203) 359-1660.
Upon receipt, inspect container and equipment for damage. Note
particularly any evidence of freight damage. Immediately report any damage
to the shipping agent
NOTE:
The carrier will not honor any claims unless all shipping material is
saved for their examination. After examining and removing contents, save
packing material and carton in the event reshipment is necessary.
2.2 REPACKAGING FOR SHIPMENT
To return the Model CYD201/CYD208, sensor, or accessories for repair or
replacement, obtain a Authorized Return (AR) number from Technical
Service in the United States, or from the authorized sales/service
representative from which the product was purchased. Instruments may not
be accepted without a RGA number. When returning an instrument for
service, OMEGA must have the following information before attempting any
repair.
1. Instrument model and serial number.
2. User name, company, address, and phone number.
3. Malfunction symptoms.
4. Description of system.
5. Authorized Return (AR) number.
Repack the system in its original container (if available). Write AR number
on the outside of the container or on the packing slip. If not available,
consult OMEGA for shipping and packing instructions.