Filter
Top Products
3. To turn back the lamp to its original brightness, press
the dimmer switch again. The LED will turn off.
4. Tor turn off the lamp while keeping the balloon inflated,
press and hold the dimmer switch for three seconds.
The LED will light red.
5. Zip up the bottom of the balloon completely after use
of the dimmer switch.
1. Turn off the power switch of the generator.
2. Turn off the Power switch. The balloon should
start to deflate and the lamp will turn off.
3. Disconnect the AC power cable from the generator.
NOTICE
To turn on lamp again, after it was turned off with the
dimmer switch, turn off the Power switch. Wait
three to five minutes then turn the switch back
on. The lamp will now light back to 100% brightness.
NOTICE
If the power cable is accidentally unplugged from
the power source, wait three to five minutes before
reconnecting the power. This will allow time for the fan
to reset and ensure balloon will inflate properly when
power is reconnected.
OPERATION
Before storing the GBC Lighting System, perform the
following steps.
1. Disconnect the lamp connector from the AC power
cable.
2. Make sure the mast is completely lowered as described
in section.
3. Unhook the AC power cable from the eyelet at the
bottom of the balloon.
4. Lock the buckle to secure the balloon together.
5. Unzip the zipper on the protective cover and pull down
cover over the balloon/lamp assembly.
6. Attach velcro tabs.
7. Loosen the T-bolt on the balloon/lamp assembly and
lift balloon/lamp assembly from the mast.
8. Release the lever on the mast holder and pull out the
mast.
9. Stow the three outriggers as detailed in the
section.
NOTICE
Allow about 15 to 20 minutes for the lamp to cool down
before storing the GBC. The possibility exists of the
balloon getting burned if it touches a hot lamp.