Filter
Top Products
COMPONENTS
Figure 3 shows the location of the controls and components
for the GBC Lighting System. The functions of each control
is described below:
1. — Stores balloon when GBC is not in
use. Allow a sufficient amount of time for the lamp to
cool down before storing balloon. Possibility exists of
balloon getting burned.
2. — Made of heat resistant polyester, with a
diameter of 47.2 inches (1,200 mm). Balloon is self-
inflating and inflates in less than 20 seconds.
3. — Used to easily attach optional message strip
to the balloon.
4. — Used to hold the balloon together when
storing inside the cover.
5. — Connects to the AC power source.
6. — Holds the generator and can be steered easily
to transport GBC to different locations.
7. — To secure the generator to the
cart platform, place clamps around the pipe frame of
the generator. Tighten securely to prevent movement.
8. — The GBC uses four pneumatic tires for easy
maneuverability.
9. — When the brake pedal is pressed, this
pad will strike and hold the rear tires in place.
10. — Allows suitcase generators to be
strapped to cart securely.
11. — Provides stability to the GBC. When
raising the mast, outriggers should always be deployed.
12. — Locks the outriggers in place when
they are deployed or stowed.
13. — Step on this pedal and pull back
T-handle to apply the brakes. To release the brakes,
press down and hold brake pedal again then release.
14. — Moves the GBC in either forward or
reverse direction by pulling back or pushing forward.
The T-handle also allows the cart to be steered left or
right.
15. — This mast is comprised of three separate
stages. The mast can be raised in excess of 8 feet
(without balloon).
16. — Loosen to raise mast and tighten to keep
the mast in place when raised to the desired height.
17. — A 12 x 43 inch
message strip (Part No. GBBALD1) may be attached
to the balloon. The message strip can be purchased
separately.
18. — Zips up balloon to completely close it when
lamp is in place.
19. — Holds lamp in place. Lamp is screwed
into socket.
20. — Used to tighten mast when
attached to the lamp/balloon assembly.
21. — Inflates the balloon as soon
as power is applied to the GBC.
22. — 1000 watt metal halide bulb with pure white
light for maximum illumination.
23. — Protects the lamp from being hit by
objects and balloon material from touching lamp.
When raising the mast, always be on the lookout for
overhead obstructions.