Filter
Top Products
FCG16HA SAW • OPERATION AND PARTS MANUAL — REV. #1 (03/19/10) — PAGE 27
OPERATION
Restarting After Intervention
If cutting is interrupted where the engine stops or is turned off
while the blade is still in the cut:
a. Turn engine Shutdown switch (next to the handle lock)
to the "OFF" position.
b. Raise the blade out of the cut
c. Restart the engine as described in the Start-Up sections
on page 24.
If cutting is interrupted where the blade is stuck in the cut:
a. Turn engine Shutdown switch (next to the handle lock)
to the "OFF" position.
b. Remove the blade guard.
c. Remove blade mounting bolt and outer flange.
d. Maneuver the saw away from the stuck blade.
e. A parallel cut made next to the blade may be necessary
to free it.
f. Once the blade is freed inspect the blade for damage;
discard if damaged.
e Ensure an undamaged, useable blade is installed on
the saw before cutting is resumed with that saw.
The only acceptable method for freeing a stuck blade is to
remove the saw from the stuck or pinched blade. DO
NOT try to get the blade unstuck using the Raise/Lower
system or by lifting the saw by the lifting bale, etc.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION