Filter
Top Products
76
*1 When a PC CPU module is used, the QCPU can be bus-connected to a programming tool by installing the programming
tool in the PC CPU module. Select "Q Series Bus" for the "PC side I/F" setting in the "Transfer Setup" window using the
programming tool.
*2 If an error has occurred, check the error cause using the programming tool and take corrective action.
An error in the CPU modules can be checked in the "PLC Diagnostics" window.
An error in the I/O modules and intelligent function modules can be checked in the "System Monitor" window.
( QCPU User's Manual (Hardware Design, Maintenance and Inspection))
Set the RUN/STOP switch of all the CPU modules to the RUN position.
Connect the CPU No.1 and a personal computer where a programming
tool has been installed.
*1
Write programs and parameters to the CPU modules. To write data to the
CPU No.2 and later, select the target CPU module in the Transfer Setup
window of the programming tool.
Reset the entire system by resetting the CPU No.1. Set the RUN/STOP
switch of the CPU No.1 to the RUN position again, and check whether no
error occurs in any CPU module in the system.
*2
Debug the program of each CPU module individually.
Run all the CPU modules.
Debug the system.
Connect to a programming tool.
Write data to the CPU modules.
Reset the CPU No.1.
Page 112, Section 5.3