Filter
Top Products
6
Main Menu - View/Edit Site Data
The VIEW/EDIT SITE DATA mode can be
accessed from the main menu. It allows
the user to enter application details for up
to 20 different sites. This facility is useful if
a number of sites are being monitored on
a regular basis. Application data can be
programmed into each site before getting
there! This also allows you to view the last
data entered and edit if required.
When scrolling up/down the menu press
ENTER to select at each prompt.
VIEW/EDIT SITE DATA
List sites
Site number 0
Name QUICK START
Units MM
Pipe O.D. 58.0
Wall thick 4.0
Lining 0.0
Wall MILD STEEL
Lining ---------
Fluid WATER
Read flow Exit
Note:
• Site Zero is always the QUICK START
data and cannot be changed.
• Changing the data in any site is
automatically saved when leaving this
menu. Data will have to be re-entered
to over ride the old data.
View/Edit Site Data - List Sites
Selecting LIST SITES allows the user to
view the names of up to 20 sites, numbers
1-5 appear first.
Pressing ENTER will display sites from 6-
10. Pressing again will display sites 11-15,
and again to display 15-20.
1 site not named
2 site not named
3 site not named
4 site not named
5 site not named
Press ENTER to continue
View/Edit Site Data - Site Number
Site number allows the user to enter the
number of the site data that you wish to be
displayed. If the site has not been used
then no data would be stored. You can
now enter new application data.
View/Edit Site Data - Site Name
Site name allows the user to edit or enter
a site name. Use the scroll keys to move
the cursor to the letter/figure required and
press ENTER to select. Press zero, to
return the instrument to VIEW/EDIT SITE
DATA. The new site name will appear on
the display.
SCROLL & ENTER
Select for space, 0 to end
abcdefghijklmnopqr
stuvwxyz01234567890
>……...............<
View/Edit Site Data - Units
Dimension units allow the user to switch
between millimetres and inches. The
software converts all the application data
in a particular site.
View/Edit Site Data - Pipe wall/lining
thickness and Pipe wall/lining material
can now be changed as required. Lining
material is ignored if a lining thickness has
not been entered. A selection of pipe
wall/lining materials will be displayed when
these options are selected.
View/Edit Site Data - Fluid type
Fluid type allows the user to scroll
through a selection of fluid types. Select
OTHER in the menu if a liquid is not
mentioned. When Other (m/s) is selected
the user must enter the liquid sound speed
in m/s. This can be supplied by Micronics
or found in the back of the manual under
Liquid Sound Speeds.
View/Edit Site Data - Read Flow
Selecting Read flow informs the user of
the mode of operation and the
approximate maximum flow rate. Press the
appropriate key can change the units
required.
Attach sensor set
in REFLEX mode
Approx. max. flow:
X.XX m/s
ENTER to continue
SCROLL changes mode
Pressing ENTER asks the user to enter a
temperature in °C.
Fluid temp? 20.0
(°C)