Filter
Top Products
PRODUCT CARE AND MAINTENANCE
WARNING:-USE ONLY BATTERIES, CHARGER, ACCESSORIES, CABLES
APPROVED FOR THIS PARTICULAR MODEL.
THE USE OF ANY OTHER TYPES MAY INVALIDATE ANY APPROVAL OR
WARRANTY APPLYING TO THE INSTRUMENT AND MAY BE DANGEROUS.
IF IN DOUBT CONTACT A MICRONICS SALES OR SERVICE
REPRESENTATIVE.
• Do not disassemble this unit unless advised by Micronics. Return the unit to the place
of purchase for further advice.
• Do not drop.
• Wipe the exterior of the instrument with a clean damp cloth or paper towel-the use of
a solvent may damage the paint surface. Ensure the unit is switched off and
disconnected from the mains.
• Do not place the instrument electronics near to naked flames or sources of intense
heat such as an electric fire or hot pipes in excess 50°C.
• Dispose of any batteries safely and in accordance with any regulations in force in the
country of operation.
• Ensure all connectors are kept clean and free from grease. They may be cleaned with
a general purpose switch cleaner.
• Avoid the use of excessive grease/ultrasonic couplant on the sensors. This may
impair the performance of the equipment. Read the instructions in the manual on how
to apply the couplant. Any excessive grease/couplant can be removed from the
sensors and guide rails using an absorbent paper towel and a general purpose
solvent cleaner.
• Regularly check all cables/parts for damage. Replacement parts are available from
Micronics.
• On fixed instruments, it is recommended the ultrasonic couplant is replaced on the
sensors every 6 months especially on pipes where the application is too hot to touch.
If signal level drops below 30% this is also an indication that the sensors need re-
greasing.
• Ensure the person who services your instrument is qualified to do so. If in doubt,
return the instrument to Micronics with a detailed report on the nature of the problem.
• Ensure that suitable protective precautions are taken when using any materials to
clean the instrument/sensors.
• Calibration of the instrument and sensors is recommended to be done at least once
every 12 months.
• If the instrument was supplied with dust or dirt caps make sure they are re-fitted when
the instrument is not in use.
• It is the users responsibility to tidy cables so they will not cause harm to other people.
• When returning product to Micronics make sure it is clean. Notify Micronics if the
instrument has been in contact with any hazardous substances.
MICRONICS Ltd
Knaves Beech Business Centre, Davies Way, Loudwater,
High Wycombe, Bucks. HP10 9QR U.K.
TELEPHONE: +44 (0)1628 810456
FAX: +44 (0)1628 531540
e-mail:
sales@micronicsltd.co.uk
Website: www.micronicsltd.co.uk
PUBLICATION Dec 2005
MICRONICS LTD
Software Version: v1.04
January 2006
21