Filter
Top Products
Trucklift Safety Instructions
2 D1 3602BA1-GB03
1.2 Further Information
At installation pay attention to the following:
Standard lifting platforms may not be operated in washing halls, rooms with high humidity or
outdoors! The lifting platform must be protected from any form of water splashing! Never
clean the lifting platform with high pressure cleaners or steam cleaners!
In rooms with very low ceilings it is recommended to install a ceiling light barrier. This can be
ordered from the manufacturer.
For safe operation pay attention to the following:
Read the standard operating procedures and user`s manual thoroughly!
MAHA will not
accept and is not liable for any claims for damage or service costs incurred due to non-
compliance with these operating instructions.
All official Accident Prevention Regulations must be thoroughly complied with!
Damages to
low-lying vehicle parts
are not covered by the warranty.
Keep the
lifting platform
and the
surrounding work area clean
.
Do not deposit any parts on the support arms or on the driving platform.
The
vehicle should be driven slowly onto the lifting platform
to avoid putting any
unnecessary strain on vehicle and lifting platform.
On
lifting platforms equipped with an axle jack
pay close attention that no objects are
below the axle jack.
Balancing work
on the lift while the platform is being
loaded
is forbidden. The vehicle may
roll off the driving platform.
Pull the parking brake
of the vehicle after entering the lifting platform.
All work done on impulse sensors and proximity switches should be carried out by
trained
electricians.
1.3 Safety Features
The TRUCKLIFT is equipped with the following safety features:
Electronic lift synchronisation monitoring
. This system monitors all the lifting carriages
and ensures that they are synchronised during lifting and lowering. If one carriage blocks all
the drive motors are switched off automatically.
Electronic bearing nut monitoring system
on all four columns. If a bearing nut breaks the
system only permits the unit to be moved to its lower starting position.
Bearing nut wear indicator
, lets you know in good time when the bearing nuts need to be
replaced.
Drive belt breakage safety system
on all four columns. All motors are switched off
automatically if a drive belt is defective.
Motor overload protection system
on all four columns.
Catch nuts
, which support the load on the lift in the event of failure of the bearing nuts.
The
main switch
doubles as an
emergency off switch
. In an emergency, the unit can be
switched off by turning the switch to position 0.