Filter
Top Products
Maintenance, Troubleshooting Trucklift
D1 3602BA1-GB03 19
S2.2 S3.2
PE
Q1
MK1
K1 K2
11
00
K5 K6
11
00
MK1
K3 K4
MK1
K7 K8
Reset
LED
ERO
F1776-422-
3471 9220/
ERO
F1776-422-
3471 9220/
230V 50/60Hz
GERTH BV 4218-1
VDE 0551 T 60/E
18V 0,25A
470nJ
o63
470nJ
o63
470nJ
o63
470nJ
o63
470nJ
o63
470nJ
o63
470nJ
o63
470nJ
o63
470nJ
o63
ON
DIP
1234
KEB
Appl.
Ver.
RESETDIP LED
Control cabinet, opened Control PCB
5.4 Lowering the Lift in the Event of a Power Failure
Remove the motor cover hoods. Each spindle can be turned separately at the large drive
pulleys with a ratchet (nut size 36) to lower the carriages. When doing this, two persons should
lower the front column pair at the same time and then the back column pair.
As soon as the power returns, synchronise the carriages again by pressing "
###
" and holding it
down until all movement stops.
The height difference between the lateral column pair should never be more than 20 mm.
The height difference between the column pair in driving direction may not exceed 100
mm!
Important:
In the event of a power failure the lifting carriages should only be lowered!