Filter
Top Products
Trucklift Maintenance, Troubleshooting
16 D1 3602BA1-GB03
c) Wear and tear on the support nut must
be checked annually. Remove the
plastic cap from the spindle cover
sheet and move the carriage slides so
that the control drill holes lines up with
the window.
If there is no visible gap this is an
indicatioin that the support nut is worn
down beyond the permissable limit.
The support nut must be replaced. The
gap is approximately 2 mm. ex factory.
When the wear limit is reached the
lift must be shut down until the
bearing nuts have been replaced.
Lock the main switch to ensure that
nobody can use the machine.
5.2 Repair Notes
Only trained, skilled electricians are allowed to check impulse sensor and proximity
switches.
Immediately contact your MAHA dealer or the MAHA service center when there are problems
with impulse sensors or proximity switches.
Unskilled work on electrical parts of the lifting platform can be life threatening.
The main switch should be switched off and secured before any repair work or
malfunction troubleshooting is done on the lift!
Malfunctions due to unskilled repair or adjustment work are not covered by the warranty.