Filter
Top Products
Trucklift Ôperation
10 D1 3602BA1-GB03
4.2 Vehicle Tracks
The vehicle tracks can be moved laterally on the
crossbars to adjust the width to match the track width
of the vehicle to be lifted. Normally, you will only need
to adjust the left track.
Track to be adjusted
To adjust the track width, first remove the retaining
pins at the front and rear. Then move the track in the
desired direction by inserting a lever in the retaining
lug and levering against one of the holes in the
perforated section below. This must be done both at
the front and the rear, otherwise the track will not be
straight.
Adjusting the track
After adjusting the track position you must
secure it again with the retaining pins!
Front retaining pin
You do not have to adjust the other track, but you can
if you wish, for example in order to centre a vehicle
over a working pit. To do this, you must first unscrew
the retaining disks on the two retaining pins, and then
unscrew and remove the pins themselves. You can
then adjust the position of the track. Since this only
needs to be done once, no leverage aids are provided.
After you have adjusted the track position you must
replace the retaining pins.
Fixed track"
Retaining pin