MOTOR
SERVICE ACCESS (WITH INTEGRAL SKIRT)
REMOVABLE SKIRT
ACCESS PANELS
ACCESS AREA
Reinstalling Panel
Hold at an angle to the skirt and insert clip under edge
of skirt opening. Bow the panel outward and insert clip
on other side.
BOW
ACCESS
PANEL
SKIRT
ACCESS
PANEL
20"
36"
24"
18"
B
A
C
SERVICE ACCESS
(CORNER BATH WITHOUT SKIRT)
A - Preferred access
B - Acceptable alternative if access A is not possible
C - Optional access for accessory equipment
RIGHT HAND UNIT SHOWN
NOTE: Left hand unit access is on the opposite
side (mirror Image).
Service Access
For partially or fully sunken installations, allow for
access to service connections. It is the installer's re-
sponsibility to provide sufficient service access. The
recommended minimum dimensions allowable for ser-
vice to the bath are shown in the "Service Access" illus-
tration.
Provide adequate area around unit for air circulation
for cooling the motor and to supply sufficient air to the
jets. Do not insulate this area or around motor.
Service Access with Skirt
An optional skirt fits along the side of the bath for
above-floor installations and is also an access panel for
servicing. Allow a space of at least 8 inches away from
the bath for skirt removal.
The skirt is designed to accommodate the added
height of the tile, linoleum, or other floor coverings up to
1-1/4 inches above the floor, and will be flush with the
floor when installed.
More detailed instructions on skirt installation are pro-
vided with the optional skirt assembly.
Service Access with Integral Skirt
Service access is through the removable skirt panels.
INSTALLATION
MOTOR
18"
18"
12"
12"
PREFERRED
ACCESS
ALTERNATE
ACCESS
SERVICE ACCESS
(WITHOUT SKIRT)
6
Jacuzzi Whirlpool Bath© U961000F 12/04
Or slide clips over bottom lip of skirt opening and tilt
up until velcro tabs make contact.
ACCESS
PANEL
SKIRT
ACCESS
PANEL