Filter
Top Products
TRD0000, TRx Owner’s Manual- Rev. 5.0, January 20, 2005
- 16 -
7.5 Using the Invacare MKV- MPJ Joystick
The MK5-MPJ joystick has four independent programmable drive selection modes: Drive 1, Drive
2, Drive 3, & Drive 4. The individual Drive modes can be selected by lifting and releasing the toggle
switch. The selected Drive mode appears in the LCD display on the joystick. Each time the toggle
switch is lifted and released it will cycle through to the next Drive mode. (i.e.; To select Drive 1 mode,
the toggle switch is lifted up once and released. To select Drive 2, the toggle switch is lifted again and
released, to select Drive 3... etc...) The controller will return back to Drive 1 after Drive 4. To operate
the power positioning system (ECU/Recline) through the joystick, a separate emergency stop
(reset) switch is typically installed. To access ECU1, tap the joystick to the left 2 times (left/left); if
ECU2 is required tap the joystick to the left 2 times and hold (left/left hold). (For complete instructions
on the set-up and operation of the power poistioning system through the joystick, please refer to the
Invacare Owners Manual). To operate the power positioning functions, the joystick can be moved in
the forward, reverse, left and right directions. The functions may be programmed* into the joystick
depending on the type of seating system and the users preferred set-up (eg. forward= tilt, reverse=
recline, etc...) The emergency reset switch must be opened in order to return to the drive selection
mode.
*Please Note: An Invacare Programmer is required in order to program/assign the specific motor
functions to the joystick. Please refer to the Invacare Manual for complete programming instructions.
7.0 Using the Power Base Joysticks
JOYSTICK
TOGGLE SWITCH
LCD Display
REMOTE On/Off PORT
Drive Select/ ON/ OFF Switch