Invacare TDX 5 Mobility Aid User Manual


 
SECTION 10—TRANSPORT READY PACKAGE (TRRO)
TDX™ Wheelchairs 74 Part No 1143150
Positioning Belts
ƽ WARNING
The angle of the pelvic belt should be
within the preferred zone of 45 to 75
degrees to the horizontal OR within the
optional zone of 30 to 45 degrees to the
horizontal.
Steeper side-view pelvic belt angles are
especially important if the pelvic belt is
intended to be used for postural support
in addition to occupant restraint in a
frontal crash. Steeper angles will reduce
the tendency for a vertical gap to
develop between the user and the belt
due to compliance of seat cushions and
belt movement, thereby reducing the
tendency for the user to slip under the
belt and for the belt to ride up on the
soft abdomen during normal use.
Steeper belt angles also reduce the tendency for upper-torso belts to pull the pelvic
belt onto the abdomen during frontal impact loading.
NOTE: For this procedure, refer to FIGURE 10.4.
1. The pelvic belt should be worn low across the front of the pelvis.
2. Position the upper-torso belt(s) over the shoulders.
3. The belt(s) should not be held away from the body by wheelchair components or
parts, including but not limited to wheelchair armrests or wheels. Refer to
FIGURE 10.4 for proper and improper positioning of the belts.
4. Ensure the belt(s) are not twisted.
5. Adjust belts as firmly as possible, being mindful of user comfort.
FIGURE 10.4 Positioning Belts
Preferred Zone
Optional Zone
Side View
30°
45°
70°
DO POSITION BELT INSIDE OF
ARMRESTS, WHEELS, ETC.
DO NOT
POSITION BELT OUTSIDE OF
ARMRESTS, WHEELS, ETC.