Filter
Top Products
SECTION 6—SEAT
TDX™ Wheelchairs 50 Part No 1143150
7. Firmly grasp the front edge of the seat assembly and slowly tilt the seat assembly back
into the up/open position.
8. Remove prop rod from the clip located on the Formula PTO Plus frame and engage
the prop rod end into the seat bracket.
9. Gently allow weight of seat assembly to be supported by the prop rod.
NOTE: Only leave the seat assembly in the up/open position while performing any necessary
procedures. Always lower the seat assembly to the down/closed position when not servicing the
wheelchair. Ensure the seat is locked in place before using.
Tilting the Seat Assembly Forward
1. Using one hand, firmly grasp the front edge of the seat assembly and lift until seat
assembly is no longer supported by the prop rod.
2. Disengage the prop rod from the seat bracket and secure into clip.
3. Using both hands, slowly tilt the seat assembly forward into the down/closed position.
ƽ WARNING
Ensure the two screws are fully engaged and the Formula PTO Plus frame is
securely locked in place before use - otherwise injury or damage may result.
4. Insert the two screws through both the Formula PTO Plus frame and the two seat
brackets.
FIGURE 6.1 Tilting the Seat Assembly
Formula PTO Plus Frame
Screw
Prop Rod
Clip
Seat Bracket
Screw
Washer
Mounting Hole