Filter
Top Products
SECTION 10—ANTI-TIPPER
Part No 1148078 59 Crossfire™Series Wheelchairs
Replacing Anti-tipper
ƽ WARNING
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to
2-inch (3.81 and 5.08 cm) clearance between the bottom of the anti-tipper wheels
and the ground/floor. This spacing should always be checked whenever adjust-
ments/changes are made to the wheelchair. Failure to maintain proper spacing may
result in the chair tipping over backward causing serious injury or property damage.
1. Press in the release button that secures the existing anti-tipper to the anti-tipper socket
and remove the anti-tipper from the anti-tipper socket.
2. Insert the new anti-tipper into the anti-tipper socket until release button engages.
3. Press in the release button on the anti-tipper bar and install the anti-tipper wheels onto
the new anti-tipper bar.
4. Repeat STEPS 1-3 for the opposite anti-tipper.
5. Measure the distance between the bottom of the anti-tipper wheels and the ground
floor.
6. If necessary, adjust the height of the anti-tippers. Refer to Adjusting Anti-tipper on
page 58.
FIGURE 10.1 Adjusting/Replacing Anti-tipper
PART NUMBER MEASUREMENT
1112178
21 - 1/8-inches
(53.66 cm)
DETAIL “A” - ANTI-TIPPER
ADJUSTMENT HOLES
Top Adjustment Hole
Anti-Tipper Bar
Release Buttons
Ground/
Floor
1-1/2 to 2 inch
(3.81 and 5.08 cm)
Clearance
Anti-Tipper Socket
Hole
Anti-Tipper
Anti-Tipper
Release
Button