Filter
Top Products
SECTION 8—WHEELS
Part No 1148078 47 Crossfire™Series Wheelchairs
Removing/Installing/ the Camber Tube
ƽ WARNING
Camber tube mounting clamps - Make sure the mounting screws are securely
tightened before using the wheelchair, otherwise personal injury or damage to the
wheelchair may occur.
NOTE: For this procedure, refer to FIGURE 8.11.
NOTE: When replacing or changing the camber tube, perform with the new camber tube.
Removing the Camber Tube
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 38.
2. Loosen the two socket screws securing camber tube to the two camber tube mounting
brackets.
3. Slide the camber tube from the camber tube mounting brackets.
Installing the Camber Tube
1. Insert the camber tube into the camber tube mounting brackets.
2. Center the camber tube in the camber tube mounting brackets.
3. Loosen the two socket screws securing camber tube to the two camber tube mounting
brackets.
4. Adjust the camber tube. Refer to Adjusting the Camber Tube on page 48.
FIGURE 8.11 Adjusting Wheelbase Length (Adjusting Center of Gravity)
Socket Screw
Socket Screw
Camber Tube
Mounting Bracket
Camber
Tube