Filter
Top Products
SECTION 5—ARMS
Crossfire™Series Wheelchairs 28 Part No 1148078
SECTION 5—ARMS
ƽ WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
DO NOT attempt to lift or tilt a wheelchair by using any removable (detachable)
parts. Lifting by means of any removable (detachable) parts of a wheelchair may
result in injury to the user or damage to the wheelchair.
Installing the Swingaway Padded Armrest Socket
Assembly
NOTE: For this procedure, refer to FIGURE 5.1.
1. Fold down the back. Refer to Unfolding/Folding the Back on page 30.
2. Install the arm socket on the arm socket plate using the two short mounting screws
and locknuts.
3. Remove the two mounting screws, coved washers and locknuts located on the back
cane mounting bracket.
NOTE: Position arm socket towards outside and rear of the wheelchair frame.
4. Align the mounting holes in the arm socket plate and wheelchair frame.
5. Using the two long mounting screws, coved washers and locknuts, secure the arm
socket plate to the wheelchair frame. Securely tighten.
6. Repeat STEPS 2-5 for the opposite arm socket.
FIGURE 5.1 Installing the Swingaway Padded Armrest Socket Assembly
Long Mounting
Screws
Back Cane
Mounting Bracket
Wheelchair
Frame
Locknuts
Locknuts
Arm Socket
Short Mounting
Screws
Coved
Washer
Arm Socket
Plate