Filter
Top Products
SECTION 9—WHEEL LOCKS
Crossfire™Series Wheelchairs 56 Part No 1148078
FIGURE 9.1 Replacing/Adjusting the Wheel Locks
Changing Wheel Lock Handle Position
NOTE: For this procedure, refer to FIGURE 9.2.
1. Loosen, but DO NOT remove, the rear handle mounting screw.
2. Remove the front handle mounting
screw and locknut.
3. Align the front handle mounting hole
with one of three desired mounting
positions on the wheel lock.
4. Using the front handle mounting screw
and locknut, secure the handle to the
wheel lock.
5. Securely tighten the front and rear
handle mounting screws and locknuts.
6. Repeat STEPS 1-5 on remaining wheel
lock handle.
FIGURE 9.2 Changing Wheel Lock Handle
Position
3/16 inch (.47 cm)
(1/8-inch) (.32 cm)
Tyre
Wheel
Lock Shoe
Mounting Screws
Wheel
Lock
Wheel Lock
Under Mount Wheel Lock
Push-to-Lock or Pull-to-Lock Wheel Locks
3/16 inch (.47 cm)
(1/8-inch) (.32 cm)
Wheel
Lock Shoe
Tyre
Mounting Screws
Wheel lock Handle
Front Handle
Mounting
Screw and
Locknut
Rear Handle
Mounting
Screw
Mounting
Positions