Filter
Top Products
Armrest Adjustment
The armrest can be pre-set for height by positioning the self-tapping screw (F) in one of
the holes in the armrest tube. To adjust the height of each armrest, first release the locking
lever (E) which clamps the arm tube, while holding onto the armrest. Move the armrest to
the desired height position, re-tighten the locking wing screw (E). The locking lever (if
fitted) can be re-positioned without losing the clamping pressure, pull the lever slightly
outwards and turn to a more suitable locating angle.
The padded side panel can also be set to a desired height. Loosen the slotted screw (D) located in the
fixing bracket, re-tighten when desired position is achieved.
Width Adjustment
The transverse width adjustment is achieved by releasing
locking lever (G) and positioning the armrest tube to width
required and re-tightening locking lever (G). To remove the
transverse width adjustment armrest assembly complete
to allow removal of the front battery box/controller
assembly: remove seat, release locking lever (G), depress
spring button lock (F) and withdraw complete armrest unit
sideways.
NOTE: When re-assembling to chair always ensure the
spring button lock (F) is on the inside of the horizontal
mounting tube of the sideframe to prevent accidental
dismantling of armrest unit.
CAUTION: The armrests are not intended for carrying the wheelchair.
5