Horn Switch
The horn will sound whilst this switch is depressed.
Lights Switch and LED
To turn on the wheelchair’s lights operate this switch, the associated LED will illuminate.
Left Turn Indicator Switch and LED
To turn on the wheelchair’s left turn indicator operate this switch, the associated LED will flash at the same
rate. If the LED flashes rapidly, one of the left turn indicator bulbs is defective, contact your authorised
INVACARE dealer.
Right Turn Indicator Switch and LED
To turn on the wheelchair’s right turn indicator operate this switch, the associated LED will flash at the
same rate. If the LED flashes rapidly, one of the right turn indicator bulbs is defective, contact your
authorised INVACARE dealer.
Hazard Warning Switch and LED
To turn on the wheelchair’s hazard warning lamps operate this switch, the associated LED will flash at the
same rate. The left and right turn indicator LED’s will also flash.
Getting Ready to Drive
Operate the on/off switch. The battery gauge will blink then turn on after a second.
Check that the maximum speed control is set to a level which suits you.
Push the joystick to control the speed and direction of the wheelchair.
Please note that if you push the joystick before or just after you switch the control system on, the battery
gauge will ripple up and down and the wheelchair will not be allowed to move. You must release the
joystick to resume normal operation. If you do not release the joystick within five seconds the wheelchair
will not be able to move, even if you release the joystick and push it again. The battery gauge will then
flash rapidly. You can reset this condition by switching the control system off and on again.
If you do not push the joystick as you switch the wheelchair on and the battery gauge flashes rapidly, then
there may be a fault.
14