Filter
Top Products
LOCKING LEVER
CAUTION: It is recommended that both footrests are firmly locked in place when
seated in the chair (particularly when driving the chair). NEVER stand on the foot-
plates. If the weight of the body is placed on the foot-plates, damage may occur and
the chair may tip forward.
ADJUSTMENT
To extend the footrest laterally, release
the winged screw A, pull the footrest
forward, re-tighten when the desired
position is achieved.
It is not necessary to release the grub
screw B. This should remain
permanently in position.
To adjust the footrest length, loosen
the hex nut C on the extension tube,
use a twisting motion when sliding the
telescopic tube in and out. Be sure to
re-tighten the nuts securely when the
desired height is achieved.
THE LOWEST PART OF THE
FOOTREST MUST BE AT LEAST
6cm (2½”) FROM THE GROUND
FOR CLEARANCE.
!
FOOTRESTS
REMOVAL - Standard
Release winged screw A and slide the complete assembly from the seat frame. Ensure the winged screw
is fully tightened when the footrest assembly is replaced.
REMOV
AL - Swing - Away
Release the locking lever, swing footrest to the side, or lift up and off. Do this before sitting in the chair.
CAUTION: It is recommended that both footrests are firmly locked in place when
seated in the chair (particularly when driving the chair). NEVER stand on the foot-plates.
If the weight of the body is placed on the foot-plates, damage may occur and
the chair may tip forward.
ADJUSTMENT
To extend the footrest laterally, release
the winged screw A, pull the footrest
forward, re-tighten when the desired
position is achieved.
It is not necessary to release the grub
screw B. This should remain
permanently in position.
To adjust the footrest length, loosen
the hex nut C on the extension tube,
use a twisting motion when sliding the
telescopic tube in and out. Be sure to
re-tighten the nuts securely when the
desired height is achieved.
THE LOWEST PART OF THE
FOOTREST MUST BE AT LEAST
6cm (2•“) FROM THE GROUND
FOR CLEARANCE.
ELEV
ATING LEGRESTS
To raise or lower, release the lock by moving
the lever forward as shown.
When lowering the legrest, support the
weight of user’s leg then release the lock,
keep it from dropping too quickly. Keep in
mind that the lowest part of the footplate must
be 6cm (2”) from the ground.
19