Filter
Top Products
6
PROCEDURE 1
P
R
E
P
A
R
I
N
G
W
H
E
E
L
C
H
A
I
R
This Procedure includes the following:
Installing/Removing Cane Clamps
INSTALLING/REMOVING CANE
CLAMPS (FIGURE 1)
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure that all attaching hard-
ware is tightened securely - otherwise injury or
damage may result.
NOTE: Refer to the INSTALLATION AND STABILITY
WARNINGS in the SAFETY SUMMARY of this manual.
Installing Cane Clamps
NOTE: The final mounting positions of the cane clamps
will be determined by the adjustments made to the Infin-
ity LoBack to fit the wheelchair and user.
1. Remove the existing back upholstery. Refer to the
wheelchair Owner's Manual.
2. Hold the Infinity LoBack up to the back canes at the
desired mounting height.
3. Visually inspect the location of the clamps on the In-
finity LoBack to determine the proper positions for
each cane clamp.
4. Loosen, but do not remove the mounting screw on
one (1) of the cane clamps.
5. Position the cane clamp on one (1) back cane, mak-
ing sure that the HEAD of the mounting screw faces
TOWARD the REAR of the wheelchair . Hand tighten
ONLY.
NOTE: It is NOT necessary to tighten the two (2) mount-
ing screws on the two (2) cane clamps at this time. The
two (2) cane clamps will be adjusted AFTER the Infinity
LoBack has been installed on the wheelchair and the
user has been evaluated.
6. Repeat STEPS 5-6 to install the other cane clamp on
the opposite back cane.
NOTE: Make sure that the two (2) cane clamps are in the
position determined in STEP 3 AND that the two (2) cane
clamps are in the same position on each back cane by
measuring the distance from the bottom of each back cane
to the bottom of each cane clamp.
PREPARING WHEELCHAIR
FIGURE 1 - INSTALLING/REMOVING CANE
CLAMPS
Back Cane
Mounting Screw
(Faces TOWARD
the REAR of the
Wheelchair)
Removing Cane Clamps
1. Remove the Infinity LoBack from the wheelchair.
Refer to
REMOVING THE INFINITY LOBACK in
PROCEDURE 3 of this manual.
2. Loosen, but do not remove the two (2) mounting
screws on the two (2) cane clamps.
3. Remove the two (2) cane clamps from the two (2)
back canes of the wheelchair.
Cane Clamp