Filter
Top Products
14
PROCEDURE 4 ADJUSTING THE INFINITY LOBACK
A
D
J
U
S
T
I
N
G
T
H
E
L
O
B
A
C
K
FIGURE 6 - ADJUSTING THE HEIGHT
Mounting
Screws
Lateral
Support
Back Panel
Upper
Mounting
Holes
Lateral
Support
Toothed
Adjustment
Slot
Lower
Mounting
Holes
Middle
Mounting
Holes
Grooves
DETAIL “A”Adjusting the Height (Figure 6)
NOTE: The lateral supports can be adjusted to three (3)
different height positions (DETAIL “A”).
1. Remove the back cushion from the back panel. Re-
fer to
INSTALLING/REMOVING THE BACK CUSH-
ION in PROCEDURE 2 of the manual.
2. Remove the two (2) mounting screws securing the
lateral support to the back panel.
3. Position the lateral support in the upper, middle or
lower position, aligning the mounting holes of the lat-
eral support with the toothed adjustment slot in the
back panel (DETAIL “A”).
NOTE: The grooves next to the mounting holes in the
lateral supports are provided to ensure that opposite lat-
eral supports are installed using the SAME mounting
holes. To ensure that this occurs, install one (1) lateral
support at the desired height position and look through
the toothed adjustment slot to see which mounting holes
have been used. Then, install the opposite lateral sup-
port using the SAME mounting holes.
4. Install the two (2) mounting screws to secure the sup-
ports to the back panel.
5. Repeat STEPS 1-3 for the remaining lateral support.
6. Torque the two (2) mounting screws that secure the
lateral support to the back panel to 45-50 in./lbs.
7. Adjust the width of the lateral supports. Refer to
AD-
JUSTING THE WIDTH in this procedure of the manual.
8. Reinstall the back cushion onto the back panel. Re-
fer to
INSTALLING/REMOVING THE BACK CUSH-
ION in PROCEDURE 2 of the manual.
NOTE: Modesty flap and fixed flap not shown for clarity.