Filter
Top Products
13
FIGURE 4 - ADJUSTING THE ANGLE
B. To DECREASE the angle of the Infinity LoBack,
grasp the TOP of the Infinity Loback and push
FORWARD.
4. Torque the two (2) nuts on the two (2) angle brackets
to 45-50 in./lbs.
5. Reinstall the back cushion onto the back panel. Re-
fer to
INSTALLING/REMOVING THE BACK CUSH-
ION in PROCEDURE 2 of the manual.
ADJUSTING THE LATERAL
SUPPORTS
NOTE: Refer to the INSTALLATION AND STABILITY
WARNINGS in the SAFETY SUMMARY of this manual.
Adjusting the Width (Figure 5)
1. Remove the back cushion from the back panel. Re-
fer to
INSTALLING/REMOVING THE BACK CUSH-
ION in PROCEDURE 2 of the manual.
2. Loosen, but DO NOT remove the two (2) mounting
screws that secure the lateral support to the back
panel.
3. Position the user in the wheelchair.
4. Slide one (1) lateral support to the desired location.
5. Torque the two (2) mounting screws that secure the
lateral support to the back panel to 45-50 in./lbs.
6. Repeat STEPS 1-4 for the remaining lateral support.
7. Reinstall the back cushion onto the back panel. Re-
fer to
INSTALLING/REMOVING THE BACK CUSH-
ION in PROCEDURE 2 of the manual.
PROCEDURE 4ADJUSTING THE INFINITY LOBACK
A
D
J
U
S
T
I
N
G
T
H
E
L
O
B
A
C
K
Mounting
Screw
Angle Bracket
TO DE-
CREASE
ANGLE:
Grasp Here
and Push
FORWARD
Mounting
Screws
Lateral
Support
NOTE: Modesty flap and fixed flap not shown for clarity.
TO INCREASE
ANGLE:
Grasp Here
and Pull
BACK
Back Panel
FIGURE 5 - ADJUSTING THE WIDTH
Slide Lateral
Support to the
Desired Location
ADJUSTING THE ANGLE (FIGURE 4)
NOTE: Refer to the INSTALLATION AND STABILITY
WARNINGS in the SAFETY SUMMARY of this manual.
1. Remove the back cushion from the back panel. Re-
fer to
INSTALLING/REMOVING THE BACK CUSH-
ION in PROCEDURE 2 of the manual.
2. Loosen the two (2) mounting screws on the two (2)
angle brackets.
3. While standing behind the wheelchair, perform one
(1) of the following:
A. To INCREASE the angle of the Infinity LoBack, grasp
the TOP of the Infinity LoBack and pull BACK.
SIDE VIEW
NOTE: Modesty flap and fixed flap not shown for clarity.
TO DE-
CREASE
ANGLE:
Grasp Here
and Push
FORWARD
TO INCREASE
ANGLE:
Grasp Here
and Pull
BACK