Filter
Top Products
42
PROCEDURE 10 BATTERIES
B
A
T
T
E
R
I
E
S
This Procedure includes the following:
Installing/Removing Batteries into/From Battery
Boxes
Connecting Battery Cables
WARNING
Make sure power to the wheelchair is OFF be-
fore performing this procedure.
The use of rubber gloves and safety glasses is rec-
ommended when working with batteries.
Invacare strongly recommends that battery in-
stallation and battery replacement ALWAYS be
done by a qualified technician.
After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may result.
NOTE: For additional battery information, refer to
PROCEDURE 11 - FWD wheelchairs or PROCE-
DURE 12 - MWD wheelchairs.
INSTALLING/REMOVING
BATTERIES INTO/FROM BATTERY
BOXES (FIGURE 1)
NOTE: To remove the battery(ies) from the battery box(es),
reverse the following procedure.
NOTE: Have the following tools available:
TOOL QTY COMMENTS
Battery Lifting Strap 1 See Note
1/2-inch (6 pt) Box Wrench 1 Not Supplied
7/16-inch (6pt) Box Wrench 1 Not Supplied
3/8-inch (6pt) Box Wrench 1 Not Supplied
Diagonal Cutters 1 Not Supplied
*NOTE: The Battery Lifting strap supplied is for Group
22 NF Batteries ONLY. Refer to the battery manufac-
turer for the proper lifting strap and/or battery tools for
U1 battery removal/installation.
WARNING
ALWAYS use a battery lifting strap when lifting a
battery. It is the most convenient method and
assures that the battery acid will not spill. It also
helps to prolong the life of the battery.
DO NOT tip the batteries. Keep the batteries in
an upright position.
NOTE: If there is battery acid in the bottom or on the
sides of the battery box(es) or battery(ies), apply baking
soda to these areas to neutralize the battery acid. Before
reinstalling the NEW or existing battery(ies), clean the
baking soda from the battery box(es) or battery(ies).
FIGURE 1 - INSTALLING/REMOVING BATTERIES INTO/
FROM BATTERY BOXES
Battery Lifting Strap
Group 22 NF
Battery Box
Bottom
U1 Battery Box
Bottom
Molded Carrying Strap
Or Hold Down Flanges
Battery Terminal(s)/Post(s)
NOTE: When securing battery lifting strap to battery,
observe polarity markings located on the ends of the
battery lifting strap, (+) side to POSITIVE (+) battery
terminal/post and (-) side to NEGATIVE (-) battery ter-
minal/post.
1. If necessary, remove the battery boxes from the
wheelchair. Refer to
INSTALLING/REMOVING BAT-
TERY BOXES in PROCEDURE 11 - FWD or PRO-
CEDURE 12 - MWD of this manual.
2. Secure the battery lifting strap to battery terminal(s)/
post(s) (FIGURE 1).
CAUTION
Some battery manufacturers mold a carrying strap
and/or hold down flanges directly into the bat-
tery case. Batteries which interfere with the bat-
tery box cannot be used for these applications.
Attempting to “wedge” a battery into a battery
box may damage the box and/or the battery.
3. Place batteries into battery box bottom.
Group 22 NF ONLY
Battery