Filter
Top Products
24
Replacing
NOTE: Observe the position of the current telescoping
front rigging support before removal to ensure correct
position of new support assembly.
1. Remove the existing telescoping front rigging sup-
port from the wheelchair.
2. Install the new telescoping front rigging support into
the wheelchair.
3. Adjust the telescoping front rigging support. Refer to
ADJUSTING TELESCOPING FRONT RIGGING
SUPPORT in this procedure of the manual.
ADJUSTING REMOVABLE
FOOTBOARD
Depth - All Models (FIGURE 8)
1. Remove the four (4) flat head screws and barrel nuts
that secure the removable footboard to the two (2)
footplate clamps.
F
R
O
N
T
R
I
G
G
I
N
G
S
FRONT RIGGINGSPROCEDURE 3
Footplate
Clamps
Removable
Footboard
FIGURE 8 - ADJUSTING FLIP-UP
REMOVABLE FOOTBOARD - DEPTH
Mounting
Positions
Flat Head Screws
Barrel Nut
Barrel Nut
2. Move the removable footboard to one (1) of the four (4)
positions.
NOTE: Before reinstalling the four (4) flat head screws,
make sure the footplate clamps are in the proper position
as shown in DETAIL "A".
3. Reinstall the four (4) flat head screws and barrel nuts
that secure the removable footboard to the two (2)
footplate clamps. Tighten securely.
Angle
ADJUSTING FOOTBOARD ANGLE - ALL
MODELS (FIGURE 9).
1. Loosen, but do not remove, the four (4) flat head screws
and barrel nuts that secure the removable footboard
to the two (2) footplate clamps.
NOTE: Because of the two (2) support tubes, the angle
of the removable footboard can be adjusted down-
ward ONLY.
2. Grasp the front of the removable footboard and ro-
tate it DOWNWARD until the desired angle is
reached.
3. While holding the removable footboard in place,
tighten the four (4) flat head screws and barrel nuts
securely.
FIGURE 9 - ADJUSTING FLIP-UP
REMOVABLE FOOTBOARD - ADJUSTING
FOOTBOARD ANGLE
Removable
Footboard
Barrel Nut
Flat
Head
Screw
Angle Can Be Adjusted
Downward ONLY
FRONT
Footplate
Clamp
DETAIL "A"
Proper
Footplate
Clamp
Position for
MWD
Wheelchairs
Proper
Footplate
Clamp
Position for
FWD
Wheelchairs