Filter
Top Products
11
ASSEMBLY
ASSEMBLY (Cont.)
9. Align the holes of the boom assembly and mast
assembly mounting bracket. Insert the bolt
completely through the holes of the mast
assembly mounting bracket and the boom
assembly (FIGURE 2).
NOTE: Be sure that the bolt is completely
through the holes of the mast assembly mount-
ing bracket and boom assembly; and they are
not riding on the shoulder of the bolt.
b. Push the control handle away from the pump
assembly.
c. If the boom assembly pivots easily, then the nut
and bolt are NOT too tight.
d. If the boom assembly does not pivot easily or
does not pivot at all, then the nut and bolt are
NOT aligned properly.
12. To check for tightness of nut and bolt (MANUAL
[CRANK]):
a. Turn the crank to raise the boom assembly.
b. Turn the crank to lower the boom assembly.
c. If the boom assembly pivots easily, then the nut
and bolt are NOT too tight.
d. If the boom assembly does not pivot easily, then
the nut and bolt are NOT aligned properly.
A
S
S
E
M
B
L
Y
FIGURE 2 - MAST ASSEMBLY
CAUTION
The boom and mast when assembled MUST
pivot easily.
10. Tighten the bolt and nut using the Allen wrench
provided and an adjustable wrench.
NOTE: The nut and bolt can be tightened
completely and the boom assembly will pivot
easily if the mounting hardware is aligned
properly when the boom assembly is secured
to the mast. To check for correct alignment of
the hardware, use the Allen wrench provided and
turn the bolt by hand (it should rotate without a
lot of force being applied). If excessive force is
necessary, the bolt is NOT aligned properly.
Disassemble and repeat assembly procedures
until proper alignment is obtained.
FIGURE 3 - SHIFTER HANDLE INSTALLATION
11. To check for tightness of nut and bolt
(HYDRAULIC):
a. Raise the boom assembly.
Base Shifter Handle Assembly (FIGURE 3)
1. Insert the base shifter handle into the cam lock
assembly at the back of the base.
2. Align the holes of the shifter handle and cam lock
assembly.
3. Tighten the thumb screw to secure the shifter handle
in place.
NOTE: This should prevent the base shifter handle
from being removed.
NOTE: For "C" Base Models 9803/9807/9819 there is
no adjustment handle.
Note: Mast Assembly Mounting
Bracket, Boom Assembly, Bolt and
Locknut MUST all be FLUSH against
each other.
Cam Lock
Assembly
Base Shifter Handle
Thumbscrew
Boom Assembly
Locknut
Mast Assembly
Mounting Bracket
Bolt