Filter
Top Products
9000 Series 58 Part No. 1056953
9000XDT (FIGURE 6)
1. Refer to the following chart or FIGURE 6 to determine the mounting position of the
amputee bracket:
2. Install the amputee bracket on the wheelchair frame to the position determined in STEP 1.
NOTE: Make sure the axle spacer is pointing towards the outside of the wheelchair.
3. Install the two (2) hex screws and locknuts that secure the amputee bracket to the wheel-
chair.
4. Install the rear wheels onto the wheelchair. Refer to
REMOVING/INSTALLING THE
REAR WHEELS in SECTION 6 of this manual.
RIGHT
LEFT
Axle Spacer Towards OUT-
SIDE of Wheelchair
REAR VIEW OF
AMPUTEE BRACKET
BRACKET "A"
BRACKET "B"
FIGURE 6 - INSTALLING THE AMPUTEE BRACKET - 9000XDT
HEMI
LEFT
HEMI
RIGHT
ADULT
RIGHT
ADULT
LEFT
TALL
LEFT
TALL
RIGHT
Locknuts
Hex Screws
SEAT- *BRACKET AXLE SPACER SIDE OF AXLE MOUNTING
TO-FLOOR POSITION WHEELCHAIR POSITION
(on bracket) (on wheelchair)
TALL A DOWN RIGHT MIDDLE
TALL B DOWN LEFT MIDDLE
ADULT B UP RIGHT BOTTOM
ADULT A UP LEFT BOTTOM
HEMI B UP RIGHT MIDDLE
HEMI A UP LEFT MIDDLE
*Note: "A" and "B" are stamped on the sides of the amputee bracket.
OPTIONSSECTION 10
OPTIONS