Filter
Top Products
9000 Series 28 Part No. 1056953
SECTION 4 ARMS
ARMS
Section 4 - Arms includes the following:
Adjusting Armrest Height
Swing-Back Arms
Replacing Desk/Full Length Armrest Pad and or Clothing Guards (Fixed Height Arms Only)
Removing or Replacing Armrest
Converting From Space Saver to Conventional Arms or Conventional to Space Saver
Arms (9000 XT/XDT Wheelchairs)
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may occur.
ADJUSTING ARMREST HEIGHT (FIGURE 1)
WARNING
Make sure the height adjustment
lever is in the locked position be-
fore using the wheelchair.
1. Unlock the armrest by flipping the
height adjustment lever on the top
front of the armrest to the UP (HORI-
ZONTAL) position.
2. Adjust armrest to one (1) of five (5)
positions.
NOTE: Height adjustment lever MUST be in
the unlocked position when placing armrest into
the arm assembly.
3. Lock the armrest by pressing the height adjustment lever into the DOWN (VERTI-
CAL) position when the desired armrest height is achieved.
4. Repeat STEPS 1-3 for other armrest.
SWING-BACK ARMS (FIGURE 2)
NOTE: This procedure applies to 9000SL, 9000XT, and 9000XDT wheelchairs ONLY.
WARNING
Make sure the armrest release lever is in the locked position before using
the wheelchair.
1. Unlock the swing-back arms by rotating the armrest release lever towards the
outside of the wheelchair.
2. Pull the front of the swing-back arm straight up/out of the arm socket and towards
the rear of the wheelchair.
3. To use the swing-back arm, push the swing-back arm towards the front of the
wheelchair and then downward into the arm socket.
FIGURE 1 - ADJUSTING ARMREST
HEIGHT
Height
Adjustment
Lever
Locked (Vertical)
Unlocked (Horizontal)
Armrest