Filter
Top Products
Bench Receiving Scale
11
Clearing a Preset Tare To clear a preset tare:
1. Remove product and container from scale platter. The
preset tare weight displays.
2. HOLD DOWN
FUNCTION
and PRESS
TARE
. The tare indicator
and last digit flashes.
3. PRESS
CLEAR
ZERO
. The set tare value clears, 0.0 displays, and
the tare indicator and last digit flashes.
4. PRESS
FUNCTION
to return to Operator Mode.
Setting Upper and Lower
Weight Limits
If you want the product to weigh a certain amount, you can
set upper and lower limits.
By setting the upper and lower limits you indicate the
maximum and minimum amount that you want the product
to weigh on the scale. The Over indicator flashes while in
the upper limit setting mode. The Under indicator flashes
while in the lower limit setting mode.
✎ Tip
Ø If the upper limit is set to zero (0.0). The over/under
mode will not work.
Ø If the upper limit is set to a smaller value than the lower
limit, an error message (------E) displays. Refer to
ERROR MESSAGES
.
To set weight limits:
1. PRESS
FUNCTION
to set the lower limit. The Under indicator
and the last digit on the display flashes.
☛ Note
To set the upper limit only, PRESS
FUNCTION
again now. The
Over indicator and the last digit on the display flashes. Go
to step 6.
☛ Note
When setting the upper and lower limit values, only the
flashing digit can be changed.