Filter
Top Products
Technical Data
332089B 23
Technical Data
NOTE: See feed system manuals for dimensions, weights, and wetted parts lists for those components. Dimensions,
weights, and wetted parts for components not covered in component feed system manuals and for combined assem-
blies are listed below.
Maximum Ambient Temperature.................... 110°F (43°C)
Maximum Operating Temp ........................ 150°F (65°C)
Maximum Outlet Fluid Working Pressure ............. 2000 psi (14 MPa, 138 bar)
Maximum Air Working Pressure .................... 100psi(0.7 MPa, 7 bar)
Minimum Air Working Pressure .................... 70psi(480 kPa, 4.8 bar)
Maximum Material Inlet Pressure................... Metal Sleeves: 1200 psi (8 MPa, 83 bar)
Plastic Sleeves: 400 psi (2.8 MPa, 28 bar)
Supplied Air Requirements........................ 1to3cfmat80psito100psi
Shot Size Range (depending on metering rods selected) 0.024 cc to 9.600 cc
Maximum Cycle Rate (application dependent, heat
required) ...................................... Upto60cycles per minute
Dimensions:
Height (to end of material inlet block):
1092-10A-2 ................................
1092-10A-4 ................................
1092-10A-6 ................................
Length:
Non Cycle Detection .........................
Cycle Detection .............................
Width:
Single Needle Outlet (Standard) ................
12.53 in. (395 mm)
17.16 in. (436 mm)
20.28 in. (515 mm)
8.38 in. (213 mm)
9.13 in. (232 mm)
1.75 in. (45 mm)
Graco-supplied Feed System Assemblies
(depends on selected options):
Smallest: 22.5 x 10 x 4 in. (572 x 254 x 102 mm)
Largest: 60 x 28 x 19 in. (1524 x 711 x 483 mm)
Weight
1092-10A-2 ................................
1092-10A-4 ................................
1092-10A-6 ................................
6-7 lb (2.72-3.18 kg)
10-11 lb (4.54-4.99 kg)
14-15 lb (6.35-6.80 kg)
Wetted Parts ................................... Metering Valve: Hardened steel, 303/304, 404, UHM-
WPE, Tungsten, carbide, fluoroelastomer, EPDM,
PTFE, Acetal
Graco-supplied Feed System Hoses and Fittings: Mild
steel, 303/304, PTFE, buna, polyethylene, polypropyl-
ene
Graco-supplied Tanks: Polyethylene, 303/304, mild steel