Filter
Top Products
Setup
12 332089B
Setup
NOTE: See Typical Installation diagram.
2.
3. Perform Setup procedure for feed system compo-
nents. See feed system manual(s).
4. Place an in-line air pressure regulator, air-water
separator/filter, and shut-off/bleed valve between
the air supply and the control solenoids.
5. Connect each 1/4 in. outside diameter supplied air
line to the corresponding control solenoid. See
Component Identification starting on page 8.
6. Connect chemical lines from feed system to meter-
ing valve material inlets. See Component Identifi-
cation starting on page 8.
Typical Installation
FIG.5
Metering Valve
Pump
Material Tank (optional)
Fluid Shut-Off Valve
Air Supply
Air Shut-off and Bleed Valve
Air Pressure Regulator
User Supplied
Air-Water Separator/Filter
Control Solenoids