Filter
Top Products
5. TO CLEAN THE BATH OR TO ADD WATER
SAFETY
: NEVER ADD WATER OR MOVE
THE BATH IF THE POWER SWITCH (ON
THE LEFT SIDE PANEL) IS TURNED ON.
RECOMMENDATION
: FOR MAXIMUM
SAFETY, UNPLUG THE UNITS POWER
CORD FROM THE ELECTRICAL OUTLET.
5.1 TURN THE POWER SWITCH (ON THE LEFT SIDE
PANEL) TO OFF POSITION TO TURN THE UNIT
POWER OFF.
BEFORE REMOVING THE BATH FILLED WITH
WATER, UNPLUG THE UNIT FROM THE
ELECTRICAL OUTLET.
5.2 Depending on usage, the water should be changed daily but
not less than once per week.
5.3 Remove the Plasma Bag Holder.
5.4 Tilt the unit to the up position by lifting the handle in front of
the control panel. With unit in up position, tighten the clamp
knob located on the top left-hand side of the device (turn the
knob clockwise.) DO NOT OVER TIGHTEN.
The unit will now be held in the up position.
It will be helpful at this point to have a cloth towel ready to
cleanup dripping water. Or, by waiting a few minutes, the
pump and heater area can drain into the water bath.
5.5 GENESIS 2002
: Carefully remove the water bath from the
device. The bath weighs approximately twenty (20) pounds
10