Filter
Top Products
LF
Serial linefeed parameter
Press “SET” to access the linefeed parameter.
LF= On
Current linefeed setting
The mode may be changed using “UP” or “DOWN” and pressing “SET”.
LF= OFF
New linefeed setting
8.11.4 IEEE-488 Parameters
The calibrator may optionally be fitted with an IEEE-488 GPIB interface. In
this case the user may set the interface address within the IEEE-488 parameter
menu. This menu does not appear on instruments not fitted with the interface.
The menu is indicated by,
IEEE
IEEE-488 parameters menu
Press “SET” to enter the menu.
8.11.4.1 IEEE-488 Address
The IEEE-488 interface must be configured to use the same address as the ex-
ternal communicating device. The address is indicated by,
AddrESS
IEEE-488 interface address
Press “SET” to access the address setting.
Add= 22
Current IEEE-488 interface address
Adjust the value with “UP” or “DOWN” and then use “SET” to set the address
to the displayed value.
Add= 15
New IEEE-488 interface address
8.11.4.2 Termination
The next paramater in the menu is the transmission termination character selec
-
tion. The parameter is indicated on the display by “EOS”. It can be set to car
-
riage return only (Cr), linefeed only (LF), or carriage return and linefeed.
Regardless of the option selected the instrument interprets either a carriage re
-
turn or linefeed as a command termination during reception.
9105/9107 41
8 Controller Operation