Filter
Top Products
4
Application Programs
Counting
Purpose
With the Counting program you can determine the number
of parts that each have approximately equal weight.
Available Features
– Store the current weight value to have it loaded as the
preset reference sample quantity next time you initialize
the Counting application
– The reference sample quantity can be changed in the
operating menu: See “Configuring the Scale”
– The average piece weight is automatically output via the
optional data interface port after initialization, if the menu
code for “Printout with data ID codes” is set
– Press [FUNCTION] to toggle the display between piece
count and weight
Factory Settings
Reference sample quantity: 10 (menu code 3. 3. 2)
Preparation
l Configure the Counting application in the
operating menu:
See “Configuring the Scale”
Menu code 2. 1. 4 Counting
l Reference sample quantity:
Menu code 3. 3. 1 5 pcs
Menu code 3. 3. 2 10 pcs
Menu code 3. 3. 3 20 pcs
Menu code 3. 3. 4 50 pcs
Menu code 3. 3. 5 100 pcs
See also “Configuring the Scale”
Example
Determine an unknown piece count; weigh the preset
reference sample quantity
Settings (changes in the factory settings required for
this example):
Menu: Application program: Counting (2 .1. 4)
Reference sample quantity: 20 pcs (3. 3. 3)
Step Key (or instruction) Display
1. Turn on the scale [ON/OFF]
2. Tare the scale t 0.000 ct
3. Display the reference [FUNCTION] ref 20 (briefly)
sample quantity > 2 sec.
(here: 20 pcs)
4. Place the reference + 16.000 ct
sample quantity
(20 pcs) on the
scale (here: 16 ct)
5. Start the application; [FUNCTION] + 20 pcs
if the print format is set
to include data ID codes,
the following is printed wRef + 0.8000 ct
6. Weigh uncounted parts + 174 pcs
(here: 174 pcs)
7. Display weight [FUNCTION] +139.200 ct
8. Display quantity [FUNCTION] + 174 pcs
9. Unload the scale 0 pcs
10. Delete the reference
value [CAL/CF] > 2 sec.
11. Repeat the procedure
starting from Step 6,
if desired.
Weighing in Percent
Purpose
This application program allows you to obtain weight
readouts in percent which are in proportion to a reference
weight.
Available Features
– Store the current weight value to have it loaded as the
preset reference percentage next time you initialize the
Weighing in Percent application
– The reference percentage can be changed
in the operating menu: See “Configuring the Scale”
– The reference percentage is automatically
output via the optional data interface port after
initialization, if the menu code for “Printout
with data ID codes” is set
– Press [FUNCTION] to toggle the display between
percentage and weight
Factory Settings
Reference percentage: 10 (menu code 3. 3. 2)