Filter
Top Products
- Eng 8 -
BATTERY REPLACEMENT
CLOCK MODE
1. To use this unit, you must install batteries, If
the battery mark “
” is displayed, you
must change both batteries.
2. Open battery cover as illustrated. Replace the
two batteries, matching the (+) and (–) polari-
ties on each battery with the polarity marks
on the case.
• To take the batteries out easily, pull the trans-
parent ribbon.
3. “LR03” batteries or equivalent are suitable for
this blood pressure monitor. All batteries used
must be same type. Do not mix alkaline, stan-
dard (carbon-Zinc) or rechargeable (cadmium)
batteries. Also, do not mix old and new batter-
ies.
1. Default time indicating state and
selection of each mode
When the battery is installed, the time and date
are set as follows.
January 1 , 12:00:00 AM
2. Setting Date and Time
1) Press the “Mode” switch then “Month” starts
flashing and press “SET” button to set the cor-
rect month. (Each time the “Set” switch is
pressed, the value of the month is increased